View Single Post
Old 3rd February 2009, 10:35 AM   #24
Lucky1
Junior Member
Member
 
Join Date: Jan 2009
Posts: 20
Default Re: Defining surfaces and other new questions....

Quote:
Originally Posted by Lucky1 View Post
If I make an "L" with a Polyline of 3 points, it appears that I cannot
"unweld" the corner vertex since it was always only one vertex.
I can't make the other tools do it either.
OK, so by the silence I will take it that once a line is drawn straight that curving only one segment of it isn't possible.
I should draw each segment separately to begin if I have any intention of curving it in the future.

Another question then if I may, once the whole piece/design is complete, and it's been given a surface,
how do I make the whole unit say 1/8" thick? Right now it's "paper thin".

Thanks!
Wes
Lucky1 is offline   Reply With Quote