AC3D Forums - View Single Post

AllenAnway · 2nd March 2011, 09:56 AM

Thanks again for your valuable advice. Here is my key question: If you remove the bolt, can you tilt the 3-D view to see through the hole that the bolt previously went through? Best wishes --- A2D2

2nd March 2011, 09:56 AM	#6
AllenAnway Junior Member Junior member Join Date: Feb 2011 Location: Superior, WI Posts: 5	Re: Make a hole in a surface Thanks again for your valuable advice. Here is my key question: If you remove the bolt, can you tilt the 3-D view to see through the hole that the bolt previously went through? Best wishes --- A2D2 __________________ A2D2