AC3D Forums - View Single Post

Edymnion · 23rd October 2013, 11:31 PM

Okay, almost finished with this one.

Exterior mesh just requires the filigree around the base of the pommel and everything will be done.

After that, its just a matter of continuing to break up the sword into printable size pieces. You can see I've already started that, but I still need to section up the blade and pull off the crossguards.

If you're sharp eyed, you may notice that I also have the slot for the steel bar in place as well.

Hoping to have everything completely finished and ready to go by the weekend. Then it'll only be... about 4 months before I get the printer. :P

23rd October 2013, 11:31 PM	#7
Edymnion Senior Member Professional user Join Date: Aug 2005 Posts: 203	Re: Sword of Omens for 3D Printer WIP Okay, almost finished with this one. Exterior mesh just requires the filigree around the base of the pommel and everything will be done. After that, its just a matter of continuing to break up the sword into printable size pieces. You can see I've already started that, but I still need to section up the blade and pull off the crossguards. If you're sharp eyed, you may notice that I also have the slot for the steel bar in place as well. Hoping to have everything completely finished and ready to go by the weekend. Then it'll only be... about 4 months before I get the printer. :P Attached Thumbnails __________________ It is by caffeine alone that I set my mind in motion. It is by the syrup of cola that thoughts acquire speed, the ears acquire ringing, the ringing becomes a warning. It is by caffeine alone that I set my mind into motion.