View Single Post
Old 5th January 2008, 11:03 PM   #6
Greasetattoo
Member
Expert member
 
Greasetattoo's Avatar
 
Join Date: Mar 2007
Location: Minnesota
Posts: 97
Default Re: Need a little help with polylines..

Captain,
Well, it worked...
I triangulated the model, then divided.
Worked.
But, when I went to combine, boom, back to black.

I read in the manual:
If after combining surfaces, the new surface appears black from every angle, this means that the first three vertices of the surface form an angle of more than 180 degrees. To prevent this, the vertex order must be changed (Surface->Change Vertex Order) so that the first three vertices of the surface form an angle less than 180 degrees.

I did what it said (Surface->Change Vertex Order).
But that did'nt work.
So, would I have to move the first 3 vertices, manually?
How do I know which are the first 3?

Thanks for all the help...
Grease
Greasetattoo is offline   Reply With Quote