Re: Sword of Omens for 3D Printer WIP
Okay, almost finished with this one.
Exterior mesh just requires the filigree around the base of the pommel and everything will be done.
After that, its just a matter of continuing to break up the sword into printable size pieces. You can see I've already started that, but I still need to section up the blade and pull off the crossguards.
If you're sharp eyed, you may notice that I also have the slot for the steel bar in place as well.
Hoping to have everything completely finished and ready to go by the weekend. Then it'll only be... about 4 months before I get the printer. :P
__________________
It is by caffeine alone that I set my mind in motion. It is by the syrup of cola that thoughts acquire speed, the ears acquire ringing, the ringing becomes a warning. It is by caffeine alone that I set my mind into motion.
|