AC3D Forums - View Single Post

Severa · 18th May 2008, 05:30 PM

Actually this extrude still haunts me. I extrude the end and the map is messed up in the TCE. I visually seem to be correcting it in the TCE and I know now how it should look. yet it is still not working on a simple extrusion. It'll usually be two sides. I'll correct one side and then move the verticles in the same way I did on the side I corrected, as it looks exactly the same, but the map blacks out in that area yet everything in the TCE looks clean. This is the most frustrating problem I've been having.

18th May 2008, 05:30 PM	#27
Severa Member Advanced member Join Date: Aug 2007 Posts: 41	Re: Sculptie Extrusion messing up UV Map Actually this extrude still haunts me. I extrude the end and the map is messed up in the TCE. I visually seem to be correcting it in the TCE and I know now how it should look. yet it is still not working on a simple extrusion. It'll usually be two sides. I'll correct one side and then move the verticles in the same way I did on the side I corrected, as it looks exactly the same, but the map blacks out in that area yet everything in the TCE looks clean. This is the most frustrating problem I've been having.