selecting element

Andy · 4th June 2006, 02:41 AM

All you are probably seeing that the mapping is all over the place. If you make a new box and open the TCE you will only see one square - this is because each surface of the box is mapped to the whole image.

Try switching into surface select mode and selecting individual surfaces, then repositioning them in the tce.

4th June 2006, 02:41 AM	#1
Andy Administrator Professional user Join Date: Jun 2003 Posts: 4,565	All you are probably seeing that the mapping is all over the place. If you make a new box and open the TCE you will only see one square - this is because each surface of the box is mapped to the whole image. Try switching into surface select mode and selecting individual surfaces, then repositioning them in the tce.