extrude along path with assembled lines

gogosAC · 21st September 2022, 03:58 PM

Thanks Andy for reply.

First, my actual working method:

placing a line with much more vertices (than I'm thinking to need) on the floor.
Afterwards, I can move them to the right position comfortably.
---------
"select the vertices in the correct order and create a single surface from the vertices."

How to create a SINGLE surface?
----------
"hold shift and control, then drag over the vertices with the left mouse button down. "

works,
but what to do afterwards, same as above?

Greetings, Gogo

PS: the mentioned "problem" is, that, if I'm using the mouse for some window-moving-zooming, the line-command is finished
-----
T select = texture on/off?

Andy · 22nd September 2022, 04:46 PM

Vertex->Create-ordered-surface will make a surface from the selected vertices.

Sorry, the "T" was a typo it should have said "To".

21st September 2022, 03:58 PM	#1
gogosAC Member Advanced member Join Date: Jun 2018 Posts: 44	Re: extrude along path with assembled lines Thanks Andy for reply. First, my actual working method: placing a line with much more vertices (than I'm thinking to need) on the floor. Afterwards, I can move them to the right position comfortably. --------- "select the vertices in the correct order and create a single surface from the vertices." How to create a SINGLE surface? ---------- "hold shift and control, then drag over the vertices with the left mouse button down. " works, but what to do afterwards, same as above? Greetings, Gogo PS: the mentioned "problem" is, that, if I'm using the mouse for some window-moving-zooming, the line-command is finished ----- T select = texture on/off? Last edited by gogosAC; 21st September 2022 at 04:12 PM.

22nd September 2022, 04:46 PM	#2
Andy Administrator Professional user Join Date: Jun 2003 Posts: 4,565	Re: extrude along path with assembled lines Vertex->Create-ordered-surface will make a surface from the selected vertices. Sorry, the "T" was a typo it should have said "To".